Putting a heater in a bathroom is a bit of a balancing act. You want it to be warm, but you’re dealing with steam and splashes. That’s why we built these wall and table heaters with an IP55 rating. In plain English? It means the housing is tight enough to keep out dust and can handle water jets hitting it from any angle. You don’t have to worry about humidity sneaking in and frying the electronics. Easy on the eyes Ever noticed how some infrared lamps have that blinding glare? It’s annoying for adults and can be way too harsh for a baby’s eyes. We fixed that by tweaking the spectral output. By using specific alloys in the filament and adding quartz coatings, we basically filter out the blinding light. You still get all the cozy heat, but without that “staring into a flashlight” feeling. How it actually works These heaters don’t waste time trying to warm up the air in the room. Instead, they send energy directly to your skin and the surfaces around you. It’s fast. Really fast. To make that happen, we used heavy-duty internal wiring that can handle the power surge needed for a quick warm-up. We also polished the reflectors to a mirror finish, which pushes the heat straight down where you actually need it, rather than letting it drift away. A few tips for installation Since you’re working in a wet room, please—get your grounding right. The IP55 shell is great for keeping water out, but a bad ground is still a risk. We always suggest using a dedicated GFCI breaker just to be safe. One last thing: these lamps pull a lot of power. If you try to cram too many onto one circuit, you’re probably going to trip your breaker the second you flip the switch. Just double-check your load calculations before you start drilling holes in the wall.